H3C S5130-EI 端口隔离配置举例
目 录
1 简介 ······························································································································· 1 2 配置前提 ························································································································· 1 3 端口隔离典型配置举例 ······································································································· 1
3.1 组网需求 ······················································································································ 1 3.2 使用版本 ······················································································································ 2 3.3 配置注意事项 ················································································································ 2 3.4 配置步骤 ······················································································································ 2 3.5 验证配置 ······················································································································ 3 3.6 配置文件 ······················································································································ 3
4 相关资料 ························································································································· 4
1 简介
本文档介绍了端口隔离的配置举例。
2 配置前提
本文档中的配置均是在实验室环境下进行的配置和验证，配置前设备的所有参数均采用出厂时的缺省配置。如果您已经对设备进行了配置，为了保证配置效果，请确认现有配置和以下举例中的配置不冲突。
本文假设您已了解端口隔离特性。
3 端口隔离典型配置举例
3.1 组网需求
如 图 1 所示：
? ? ?
Site 1 和 Site 2 是某公司的两个部门，分别在 VLAN 2 和 VLAN 3 上承载业务，并接入
Device A。
Device A 通过 GigabitEthernet1/0/1 端口与外部网络相连。
公司希望这两个部门都可以通过 Device A 和外部网络通信，但两部门内部的二层流量都互相隔离。
图1 配置端口隔离组网图
三层交换机05-端口隔离配置举例
