l29, the company responsible for a variety of procedures for reimbursement document, invoice review, approval of work; 30, regularly convened general meeting of shareholders, preparation work for the meeting; 31, the company responsible for payroll management jobs, including around salary survey, employee salary, salary accounting methods developed, payroll accounting, payment of wages, bonuses; 32, the company responsible for delivery of financial procedures; 33, according to the company's strategic development plan, the preparation and management of funds to meet day-to-day operating funding requirements to ensure the company's safety, liquidity and profitability of the funds; 34, responsible for the environmental protection building materials Corporation issued by the Corporation Annual, monthly economic indicators in the assessment of the economic responsibility system of proposed amendments; 35, the company responsible for all types of contracts and tracking, implementation, implementation of the agreement, abnormality was detected in time to take appropriate measures and feedback to the leadership; 36, regularinspection, analysis, budget implementation of the business and financial performance, and to propose measures to increase revenue and reduce expenditure; 37, responsible for organizing the company's contracting business tenders; 38, responsible for preparing the annual budget and final accounts, distribution of profits, loss compensation plan; 39, responsible for the violations of financial discipline, or damage the company's interests (corruption and bribery) review of the Act; 40,注1﹑在清洗之前必须检查压缩空气是否关闭，若无，关闭压缩空气； 意事2﹑随时保持设备的周围卫生状况，撤去不必要的物品。 项 编制 技术部 审核 赖嘉雄 批准 赵荣茂 福建爱婴日用品有限公司作业指导书 真空乳化机安全操作规程 开始实施日期 2013年11月15日 文件编号 修改状态 页 次 WI-01-019A 0/A 第1页 共1页 使用前检查水、电是否正常，调试机台运转是否正常 → 关闭所有阀门，然后按配方将原料投入油、水箱内 → 开启总电源，并开启油、水箱的电加热，开启阀1、2、5、8、9。等到加热快完成时，安束后，就关闭阀1、11、20 → 开动真空系统，开启阀14、15，待锅内真空度到200mmHg(－0.03Mpa)，全 开启阀4和13，待水相吸进一半时关闭阀4，并开启阀10，当油相吸完后关闭阀10，并开启阀4直至操水相吸完，关闭4、13、14、15，然后停止真空系统 → 开动均质机5－15分钟，停止后开刮板搅作拌机及真空系统，开启阀14、15，当锅内真空达400mmHg(－0.055Mpa)时即关闭阀14、15，后停止真空系统（真空度不宜太高，以免锅内液体沸腾）。这时可开启阀21和12,夹套内通冷却水冷却,当物料达流到要求的温度(视工艺要求)加香精到香精料斗中，稍稍开启针型阀17，吸完后，关闭阀17，尽量不要放程 进空气 → 待乳化剂配制完毕后，停掉刮板搅拌机，开启阀14、16破真空，物料由阀18放出，最后用压缩空气把残料压出 → 一次操作完毕后要开启阀19和12，把乳化锅内夹套内水放掉。 开动搅拌器，使物料混合均匀，然后关闭2、5、8、9，并开启阀11、20，对乳化锅进行预热，预热结l29, the company responsible for a variety of procedures for reimbursement document, invoice review, approval of work; 30, regularly convened general meeting of shareholders, preparation work for the meeting; 31, the company responsibleor payroll management jobs, including around salary survey, employee salary, salary accounting methods developed, payroll accounting, payment of wages, bonuses; 32, the company responsible for delivery of financial procedures; 33, according to the company's strategic development plan, the preparation and management of funds to meet day-to-day operating funding requirements to ensure the company's safety, liquidity and profitability of the funds; 34, responsible for the environmental protection building materials Corporation issued by the Corporation Annual, monthly economic indicators in the assessment of the economic responsibility system of proposed amendments; 35, the company responsible for all types of contracts and tracking, implementation, implementation of the agreement, abnormality was detected in time to take appropriate measures and feedback to the leadership; 36, regularinspection, analysis, budget implementation of the business and financial performance, and to propose measures to increase revenue and reduce expenditure; 37, responsible for organizing the company's contracting business tenders; 38, responsible for preparing the annual budget and final accounts, distribution of profits, loss compensation plan; 39, responsible for the violations of financial discipline, or damage the company's interests (corruption and bribery) review of the Act; 40, 1、在乳化锅内没有物料时严禁开动均质机，以免空转损坏； 2、乳化锅内真空度不宜过高，以免引起水沸腾； 注4、水、油相锅投固体物料时应小心，不要拥在搅拌轴或浆叶上，以免造成损坏； 意5、如发现均质机卡机，应迅速关掉电源，并拆下修理； 事6、如乳化锅漏真空，应检查均质机上部或底部的机械密封以及各阀门的密封； 7、搅拌轴承密封座内每6个月加入黄油一次，以免损坏轴承。 项 3、夹套蒸气进口要装安全阀； 编制 技术部 审核 赖嘉雄 批准 赵荣茂 福建爱婴日用品有限公司作业指导书 粉搅拌机安全操作规程 开始实施日期 2013年11月15日 文件编号 修改状态 页 次 WI-01-020A 0/A 第1页 共1页 l29, the company responsible for a variety of procedures for reimbursement document, invoice review, approval of work; 30, regularly convened general meeting of shareholders, preparation work for the meeting; 31, the company responsible for payroll management jobs, including around salary survey, employee salary, salary accounting methods developed, payroll accounting, payment of wages, bonuses; 32, the company responsible for delivery of financial procedures; 33, according to the company's strategic development plan, the preparation and management of funds to meet day-to-day operating funding requirements to ensure the company's safety, liquidity and profitability of the funds; 34, responsible for the environmental protection building materials Corporation issued by the Corporation Annual, monthly economic indicators in the assessment of the economic responsibility system of proposed amendments; 35, the company responsible for all types of contracts and tracking, implementation, implementation of the agreement, abnormality was detected in time to take appropriate measures and feedback to the leadership; 36, regularinspection, analysis, budget implementation of the business and financial performance, and to propose measures to increase revenue and reduce expenditure; 37, responsible for organizing the company's contracting business tenders; 38, responsible for preparing the annual budget and final accounts, distribution of profits, loss compensation plan; 39, responsible for the violations of financial discipline, or damage the company's interests (corruption and bribery) review of the Act; 40, 1、前检查各部位是否正常，送上电源，将加热板调至生产所需要温度； 安2、按配方要求称取所需原料，依次投入搅拌机内，启动设备运转； 全 操3、设定搅拌所需时间内约15—20分钟，搅拌时间到，设备自动停机； 作 流4、打开锅盖，检查物料搅拌是否均匀，合作后出料； 程 5、及时清理设备外壳粉尘，保持设备外观整洁。 1、配制物料不可超过该设备总容量； 注意2、设备运行中，禁止打开锅盖； 事项 3、按要求设定温度，禁止随意增加温度，延长搅拌时间，以免损坏加热板。编制
技术部 审核 赖嘉雄 批准 赵荣茂
主要设备安全操作规程 - 图文
