电梯使用维护手册
MAINTENANCE MANUAL
MMMMMMMMMMMM
INDEX 目 录
Chapter 1Car position / Access 第一章 轿箱定位及进出井道程序
1Door Switch Bridge Device…………………..………………………………1
门锁短路器
2Pit Access………..…………………………………………..…………………..4 进入底坑
3Hoistway/Position Access.……..….………………………….……………6进出井道/轿顶程序
4Fireman’s Access to Controller or Machine……………………………13接近控制柜或曳引机
Chapter 2Maintenance visits
第二章 保养检查
1. Maintenance , Minor or Commercial visit………………..……………17
保养例行检查
2. Maintenance Procedure Major……………………….……………….……21
常规计划保养
Chapter 3Maintenance / minor repair
第三章 常规保养/初级修理
1
Battery replacement………….…………………………………..…………29 电池的更换
2Belt tensioning Procedure………………………...………………………..33 曳引带张力的调整
3Car guides shoe replacement………………...……………………………35 轿箱导靴的更换
4CSB Visual Inspection……………………………………………………….37 曳引带的查看
5CSB Inspection Procedure.…………………………….……..……………45 曳引带的检测程序
6. CSB Cleaning…………………………………………………………………55
曳引带的清洁
i
1
2345678.
1. 2.
Chapter 4Passenger rescue
第四章 困人解救
Recommended Application of the passenger rescue procedures……………….………….……………………………………………56 建议使用的乘客救援程序
Rescue , Porter……………………….………………………….……………65 断电解救程序
Rescue, Balanced Load…………………………………………………...…68 平衡负载时的解救
Rescue or Raising the car on a Brake Coil Failure……………………70 制动器线圈故障时的解救
ERO Rescue.…...………………………………………………………………72 ERO解救
Passenger rescue procedure - Opening under toe guard…….……74 轿箱下方存在危险间隙时的解救
Counterweight Safety Release……………………………………………76 对重安全钳的释放
Rescue, extroadinary………………………………………………………..82 特殊救援程序
Chapter 5Turn over tests
第五章 交接测试
EN 81 test procedures………………….…………………………………..87 EN 81 测试程序
One shoe Brake tests…………………………………..……………..…117 单靴制动测试
Chapter 6Major repair
第六章 大修
1. JHA : Job Hazard Analysis……………………………….………………121
工作危险分析
2. Belt shortening procedures………………………………….…………..138
曳引带截短 3. re-roping procedures.……………………………………………….…….144
曳引带更换
4. Moving the car with a brake coil failure at Top landing……….…..150
轿箱位于顶层时出现制动器线圈故障的处理
5. Brake removal procedures….……………………………………………156
制动器的更换 6. Controller replacement…………………………………………………...163
ii
控制柜的更换 7. Encoder replacement……………………………………………………...165
编码器的更换 8. Governor replacement……………………………………….……………168
限速器的更换
9. Machine replacement procedures……………………………………...171
曳引机的更换
10. Belts Sheave removal procedures.……………………….….…………182
轿顶曳引带轮的更换
11. Break adjustment…………………………………………………….……..187 制动器的调整
iii
OEC-F OTIS ENGINEERING CENTER - FARMINGTON Gary L. Nuschler GeN2: Door Switch Bridge Device 门锁短接器 FAA29190AS_FM2_BRIDGE OtisA United Technologies Company PAGES: 3, 1/16/01
Introduction: This document will guide elevator personnel to safely operate the elevator while bridging door locks using the FAA29190AS door switch bridge device.
简介本文指导如何使用FAA29190AS门锁短接器及使用此短接器时如何安全操控电梯
TASK # 工序编号
TASK DESCRIPTION
工序描述
Determine if passengers are in elevator. Rescue passengers
确定电梯内没有乘客如果有则将乘客放出 .
Apply labels to hoistway doors alerting building occupants that elevator is out of service. Assure all hoistway doors are closed
在厅门上贴制工作警示标志同时通知业主电梯将停止服务确认所有的厅门都正常安全关闭 .
If elevator can run, move elevator to landing below top floor.
如果电梯可以运行则将电梯开至次顶层
Open hoistway door and determine how far top of car is located above or below top landing.
打开厅门确定轿顶高于或低于顶层的距离为多少
TOOLING 工具
COMMENT
说明
1.
2.
out of service labels 电梯停止服务标志
3.
service tool SVT工具
This allows access through entrance adjacent to E&I panel if possible 如果可以则通过E&I操控盘进行.
4.
door key 厅门锁匙
5.
Move elevator to a level where top of car is accessible
运行电梯到可以进入轿顶的位置.
If elevator can run, use ERO in E&I panel. If elevator cannot run, use manual rescue procedure
如果电梯可以运行则使用E&I.操控盘上的ERO功能如果电梯不能运行则采用手动救援的方法
1
gen2电梯使用维护手册
