低压条件下PY115型摇臂式喷头水力性能试验
朱兴业;袁寿其;刘俊萍
【期刊名称】《农业机械学报》 【年(卷),期】2011(042)011
【摘要】针对喷头在低压条件下工作时水力性能较差的问题,提出采用异形喷嘴降低水滴打击强度并改善喷洒均匀性的方法.选取PY115型摇臂式喷头为研究对象,设计了3套改进喷嘴的方案,在出口喷嘴上增加了1、2、3个凹槽,凹槽的尺寸均为宽0.5 mm,高0.3 mm,位置分别在出口喷嘴下方和左右两侧.在工作压力为200 kPa下进行了试验测量,同时在正方形组合间距为13～18 m时,采用Matlab语言编制程序对其进行了仿真计算.试验和计算结果表明:在低压条件工作时,随着凹槽数量的增多,流量增大,射程缩短8.1％ ～9.4％,末端水滴直径降低系数为2.9％ ～ 6.8％,平均喷灌强度增大并均符合规范要求.增加凹槽有利于提高组合均匀系数,出口喷嘴增加3个凹槽时效果最佳,组合均匀系数最高超过90％,证明了所设计异形喷嘴方案的可行性.%To overcome the poor hydraulic performance problem of impact sprinkler when operating at low pressure, a program of modifying the shape of outlet nozzle was put forward. It was used to reduce the droplet impact strength and improve the uniformity coefficient. Impact sprinkler typed PY,15 was chosen and three improved nozzles were designed. One, two or three notches were to be added in the outlet nozzle, respectively. All the notches were 0. 5 mm in width and 0. 3 mm in height and they were set at bottom, left or right side of the outlet nozzle. Experiments were
carried out under the low operating pressure of 200 kPa. When the rectangular spaces were 13 m to 18 m, Matlab was used to establish a program to simulate the hydraulic performances. The results showed that with the increase in the number of notches, the flow-rate increased, the wetted radius were shortened by 8. 1% to 9.4% , the reduced coefficient of droplet diameter was 2. 9% to 6. 8% , the average irrigated intensity increased and complied with national requirement. The combined uniformity coefficient was improved for all the improved nozzles. The effect was more obvious when three notches were added in the outlet nozzle and the maximal uniformity coefficient can be more than 90% . Modifying nozzle shape was proved to be an available program as a result. 【总页数】5页(76-80)
【关键词】摇臂式喷头;低压;水力性能;异形喷嘴;均匀系数 【作者】朱兴业;袁寿其;刘俊萍
【作者单位】江苏大学流体机械工程技术研究中心,镇江212013;江苏大学流体机械工程技术研究中心,镇江212013;江苏大学流体机械工程技术研究中心,镇江212013
【正文语种】中文 【中图分类】S277.9+4 【文献来源】
https://www.zhangqiaokeyan.com/academic-journal-cn_transactions-
chinese-society-agricultural-machinery_thesis/0201258201096.html 【相关文献】
1.低压条件下热式气体流量传感器测量方法的研究 [J], 宋彦峥; 薛前; 尹林 2.常压灌水器在低压条件下水力性能试验研究 [C], 马晓鹏; 龚时宏; 王建东; 田金霞; 胡明罡
3.ZL205A合金铸件在机械振动和低压条件下的爆发式补缩机制 [J], 王汝佳; 吴士平; 陈伟
4.低压条件下多孔材料水分迁移过程研究 [J], 陈磊; 王树刚; 张腾飞; 梁运涛 5.低压条件下“拳杏”果实的乙烯代谢 [J], 李嘉瑞; 周燕飞
以上内容为文献基本信息，获取文献全文请下载
低压条件下PY115型摇臂式喷头水力性能试验
