多间隙气体开关触发放电过程及击穿抖动
丛培天;邱爱慈;孙铁平;盛亮;李阳;张美
【期刊名称】《强激光与粒子束》 【年(卷),期】2013(025)005
【摘要】实验研究了开关闭合抖动随欠压比和脉冲触发电压的变化关系,利用紫外光纤探测器测量不同间隙放电时延,分析了放电过程对多间隙开关闭合抖动的影响,并研究采用预电离方法降低开关触发电压.实验表明:开关抖动随脉冲触发电压与欠压比的乘积增大呈指数下降趋势；当触发电压和欠压比的乘积大于33kV时,开关抖动小于5 ns;乘积大于45 kV时,开关抖动降到3 ns以下并趋于饱和；对六间隙气体开关抖动的贡献,触发间隙占30％～40％,其余5个间隙为60％～70％；欠压比和触发电压对触发间隙击穿抖动的影响最大,对随后放电的3个间隙影响较小,对最后2个间隙几乎无影响；当欠压比大于57％时,采用预电离措施使开关的触发电压降低了10 kV以上.%Closure jitter versus voltage ratio and trigger voltage was experimentally measured for a six-stage gas switch. An ultra-violet fiber system was used to diagnose the discharge process influencing the closure jitter, and a pre-ionizing measure was employed to decrease the trigger voltage. It is found that the switch closure jitter declines exponentially with the product of trigger voltage and voltage ratio. The trigger gap accounts for 30%-40% of the closure jitter while the other five gaps account for 60%-70%. The trigger voltage and voltage ratio have more influences on the jitter of the trigger gap which breaks down first, than on that of the three gaps
discharging subsequently, and hardly affects the last two gaps. For the switch with a voltage ratio greater than 57%, the pre-ionizing measure finally lowers the trigger voltage by over 10 kV. 【总页数】4页(1303-1306)
【关键词】气体开关;欠压比;闭合抖动;触发电压;光纤探测器 【作者】丛培天;邱爱慈;孙铁平;盛亮;李阳;张美
【作者单位】西北核技术研究所强脉冲辐射模拟与效应国家重点实验室,西安710024
【正文语种】中文
【中图分类】TM836;TL51 【文献来源】
https://www.zhangqiaokeyan.com/academic-journal-cn_high-power-laser-particle-beams_thesis/0201236540100.html 【相关文献】
1.六间隙串联气体开关触发放电过程 [J], 孙铁平; 丛培天; 李阳; 黄涛; 盛亮; 王亮平; 曾正中
2.气体开关触发间隙与过压间隙击穿特性研究 [J], 翟戎骁; 黄涛; 丛培天; 罗维熙; 王志国; 张天洋
3.气体触发开关击穿过程的光学测量实验研究 [C], 门涛; 高景明; 刘列; 文建春 4.基于六间隙棒电极结构的沿面击穿型触发真空开关的工作特点（英文） [J], 戴玲; 周正阳; 南敬; 王延召; 林福昌
5.小型场畸变气体开关的击穿抖动特性 [J], 张恺烨; 宋法伦; 张北镇; 张琦; 甘
延青; 龚海涛; 金晓
以上内容为文献基本信息，获取文献全文请下载
多间隙气体开关触发放电过程及击穿抖动
