精品--
EPS线条安装步骤：
安装侧面图：
第一步：将特制胶浆与特制水泥所调制的混合物按1.5:1之比例配合，搅拌均
匀后称为特制粘贴胶浆（或使用高分子益胶泥）。
The special mucilage and special cement mixture of the modulation by 1.5:1 the proportion coordination, stir called special paste mortar (or use the polymer cement)
第二步：清洁好安装基面，不可有任何杂质，在墙体预定上水泥钢钉（间距
700mm左右）以防在安装过程中构架滑落。
Clean good installed base, do not have any impurity, in wall scheduled on cement steel nail (spacing 700 mm or so) in case in the installation process frame slide.
--精品
精品--
第三步：按实际需要的长度切割构建，切割完毕后，立即拼凑核对。在拼凑处，露出泡沫面的地方涂抹上粘贴胶浆或高分子益胶泥。迅速拼接好。 According to the actual needs of the length cutting construction, cutting, immediately upon the completion check together. In the piece together place, revealing the foam place daub paste mortar or polymer profit cement. Rapid together again.
第四步：将构件背面涂上粘贴胶浆，立即安装。利用水泥钉固定不动（2-4小时），轻推调整构件位置，确保校直所有衔接处，拼凑整齐。
Will the back member with paste mucilage, immediately installation. Use of masonry nail fixed (2-4 hours), jog adjustment member position, ensure straightening all join place, piece together neatly
--精品
精品--
第五步：多余的特制水泥胶应该用刮刀或者腻子刀除去，污迹应用湿布或者毛剔除去。如有表面破损，应涂抹上特制水泥砂，再用60硬度砂纸打磨，保证构件表面毫无缺陷。
Extra special cement should use the scraper or putty knife to remove, smudges application wet cloth or hair to eliminate. If there is a surface damage, should daub special cement sand, reoccupy 60 hardness sanding, ensure the component surface without defect.
--精品
EPS线条安装步骤
