TEI-7.5-056-F002 Validation Report_Project Name_Model Name_Station Name_####_Version

Contact:

Contact Number (direct): Contact Number (fax): Mail Address:

Contact:

Contact Number (direct): Contact Number (fax): Mail Address:

Test Equipment Validation

Tester Type: Project Name: Current revision: Release Date: Psion Doc #: Flex DOC#: Project Name_Model Name_Station Name_####_Version

Revision

Date Author REVISION HISTORY Description of Change Name (printed)

Title APPROVALS (Flextronics) Signature* APPROVALS(Psion) Signature* Date Name (printed) Title

*If file is sent electronically, actual signature will be available on hard copy file.

Date 1/4

TEI-7.5-056-F002 Rev A

1

INTRODUCTION ................................................................................................................................ 3

1.2 Purpose of this document .................................................................................................................... 3 2.2 ACRONYMS AND ABBREVIATIONS ............................................................................................ 3 2 3 3.1. 3.2. 4 5 6 7 8 9

BASIC INFORMATION, SPECIFICATION AND PARAMETERS ............................................. 3 REPEATABILITY PROCESS CAPABILITY ANALYSIS ............................................................ 3 Repeatability (Cg Calculations)...................................................................................................... 3 Process Cabapility (Cp / Cpk Calculations) .................................................................................. 3 TEST SPECIFICATION DEFINED .................................................................................................. 3 TEST PROGRAM CAPABILITY QUALIFY .................................................................................. 3 TEST PROGRAM VERSION CONTROL ....................................................................................... 4 TESTER ORIGINAL LOGS .............................................................................................................. 4 SAMPLES INFORMATION .............................................................................................................. 4 PERFORMANCE OF ANALYSIS ..................................................................................................... 4

2/4

TEI-7.5-056-F002 Rev A

1 Introduction

1.2 Purpose of this document

1.1 ACRONYMS AND ABBREVIATIONS 2 Basic information, specification and parameters

3 Repeatability process capability analysis

This analysis is systematically done for test fixture and program. This process is implemented as below calculation formula.

The target for both calculations is: > 1, 67

Verification / Validation of test equipment by statistical methods (short term analyses)

Automotive: MSA (Measurement System Analysis)

3.1. Repeatability (Cg Calculations) 1 Product / 50times measured Double sided limits Cg = (0,2 x T) / (6 x s) >= 1,67 one side limit: Cpkul , Cpkol >= 1,67

digital measurement: always ?Pass“

T = Upper limit – lower limit s ... Standard deviation

3.2. Process Cabapility (Cp / Cpk Calculations)

min. 50 Products / 1 x measured

double sided limits Cp = T / (6 x s) >= 1,67

Cpk = min(Cpku, Cpkol) >= 1,67 Cpku = (Xm – UL) / 3 s Cpkol = (OL – Xm) / 3 s Xm ... Man value one side limit : Cpkul , Cpkol >= 1,67

Digital measurement: always “Pass“ 4 Test specification defined

5 Test Program Capability Qualify

Installed/ Configuration Non-installed Detected for existence Detected for nonexistence TEI-7.5-056-F002 Rev A

3/4

6 Test program version control Test Program Name Model 7 Tester original logs 8 Samples information

9 Performance of analysis

Version Revised Date Revised by comment 4/4

TEI-7.5-056-F002 Rev A